meta data for this page
Translations of this page:
- en
Fequency measurement
ToDo @ ResLab
- [✓ klaus, 2018-10-31]
Test new virtuel beat setup- [✓ klaus, 2018-10-31]
without EDFA - [✓ klaus, 2018-10-31]
with new electronic box - [✓ klaus, 2018-10-31]
Faserlink zur PTB kompaktifizieren - EDFA wieder einbauen
- Qt-Programm erneuern
- MASER: Sync vs GPS (over 1 week) and correct for deviations
- Synteziser als Driftkorrektur verwenden? * <todo #klaus:2018-10-31>10MHz Verteilung * Frequenzkamm * <todo #klaus:2018-10-31>Passive Stabilität Faser von R1 zum Frequenzkamm testen
- Neue Photodioden im Frequenzkamm nutzen?
- Spiegel im Freuqenzkamm untersuchen für mehr Leistung (Signal zu Rausch)
- Gitterfrequenz mit Frequenzkamm während Frequenzmessung messen?
- Uhrenlaser
- TA-Auswirkung auf uhrenlaser-linienbreite?
- Uhrenlaser faser vom reslab zum atomlab umbauen und tauschen
- Akustikbox zumachen
- Analyze: all error signals
- Reprate
- Ceo
- Intensity lock R1
- PDH Lock
- TA Lock
- Fiber stabilization
- Resonator 2 in betrieb nehmen?
- Siliziumcavity auf R1 übertragen?
- Labview Programm einpflegen
* [✓ klaus, 2024-04-29] What are the limitations of the frequency comb?
ToDo @ AtomLab
- AC Stark shift: Clock laser
- [✓ fim, 2017-01-24]
measure the clock laser waist - [✓ fim, 2017-01-24]
focused or kollimate clock laser? - AC Stark shift: Lattice Laser
- Recheck magnetic fields: Compensation Coils and Hom. Coil
- measure Zeemann
- collisions?
- shut off stabilizations: influence on the linewidth?
- Stability of the clock: Make selfcomparison and check averaging
ToDo after
- check all values