meta data for this page
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
groups:mg:red_pitaya [2022/11/30 15:36] – [Step by step: basic communication with red pitaya (SSH)] fiene | groups:mg:red_pitaya [2024/03/20 09:37] (current) – Admin: Syntax-Update (Migration from deprecated "fontcolor" plugin to "color" plugin) klaus | ||
---|---|---|---|
Line 7: | Line 7: | ||
Check the LED's to eventually detect some first problems: | Check the LED's to eventually detect some first problems: | ||
- | * <fc # | + | * <color # |
- | * <fc # | + | * <color # |
- | * <fc # | + | * <color # |
- | * <fc # | + | * <color # |
For the basic communication with the file system an SSH-connection works fine. You can use PuTTY to create it. To find out which IP-address your Red Pitaya has by checking all IP-addresses in your private network. Therefor you can enter the command '' | For the basic communication with the file system an SSH-connection works fine. You can use PuTTY to create it. To find out which IP-address your Red Pitaya has by checking all IP-addresses in your private network. Therefor you can enter the command '' | ||
Line 56: | Line 56: | ||
All commands in the style of '' | All commands in the style of '' | ||
- | python version | + | Python |
+ | |||
+ | Note that if you want to use PyRpl, you'll need Python 3.6, due to PySide. If you have Python 3.5 installed, remove it with '' | ||
+ | |||
+ | To install Python 3.6 on Ubuntu 16.04.7 you first need to install the dependencies with '' | ||
- | First run '' | ||
- | then install some packages: '' | ||
- | '' | ||
If you want a specific python3 version, you have to specify, e.g.: | If you want a specific python3 version, you have to specify, e.g.: | ||
'' | '' | ||
To make this version of python your default version, do the following: '' | To make this version of python your default version, do the following: '' | ||
- | Note that if you want to use PyRpl, you'll need Python 3.6, due to PySide. On Ubuntu 16.04.7 you can upgrade Python as described [[https:// | + | To install pyrpl via pip first install and upgrade pip (if you have a lower version than pip 21.0) with '' |
- | + | ||
- | To install pyrpl via pip first upgrade pip if you have a lower version than pip 21.0 with '' | + | |
Troubleshooting: | Troubleshooting: | ||
Line 81: | Line 80: | ||
| rp-f096cb | | rp-f096cb | ||
- | The first 6 have Ubuntu 16.04.7, Python 3.5.2 and pip 20.3.4 installed. | + | The first 4 boards |
==== PID-Controller Board in the Atom Lab==== | ==== PID-Controller Board in the Atom Lab==== | ||
* PID-Controller: | * PID-Controller: |