meta data for this page
Translations of this page:
- en
This is an old revision of the document!
02.11.2016
- 8x sinkings for the vitonballs in each panel:
- We measured the diameter of the glasballs and saw an inaccuracy of 80mm +/- 20müm. Therefore we put the balls in an 5mm hole and measured the ball-high in different position with the CNC-maschine:
- After the “ball-high-measurement”, we calculated the mean value and drilled the test-holes, for example “Kugel 1” 5mm + 19.4müm, and measured again. We saw a really nice result! After a 1cm test-milling and a good result, we milled in the mounting-breadboard:
