meta data for this page
Translations of this page:
- en
02.11.2016
- 8x sinkings for the vitonballs in each panel:
- We measured the diameter of the glasballs and saw an inaccuracy of 80mm +/- 20müm. Therefore we put the balls in a 5.Xmm test-hole and measured the ball-high in different position with the CNC-maschine:
- After the “ball-high-measurement”, we calculated the mean value and drilled again test-holes, for example “Kugel 1” 5.Xmm + 19.4müm, and measured again. We saw a really nice result! After a 1cm test-milling and a good result, we milled in the mounting-breadboard:
- We build everthing together and measured the high of the mounting on different places with a provisional result of +/- ~80müm:
