meta data for this page
  •  
Translations of this page:
  • en

This is an old revision of the document!

19.10.2016

  • I cleaned the vacuum chamber

  • I tested the all M6 holes from the vacuumchamber --> all threads are deep enough!

  • 2x M4-breadboards (incouple and outcouple) and there spacers are done!
  • I assembled the mounting with vitonballs and zerodur rods. --> We need two vitonballs of each metal sheet side. Otherwise the mounting is to wobbly! --> 8x new sinkings for the vitonballs! If you fixed the mounting screws: tighten them crosswise!!!

  • Leaktest --> positiv :-/ --> New weld!