meta data for this page
  •  
Translations of this page:
  • en

This is an old revision of the document!

Fiberlaser

Close the program “Fiber Comb Control”, otherwise you can´t optimize the comb!

  • Push Yes

  • Push OK

  • If you turn off and on the freuqency comb, then push in the order:
    1. Reset
    2. Auto on
    3. Enable on
The program is done, if all four boxes [Laser on, Modelocked, Autoscramble, Enabled] are green!
  • For closing the software:
    1. Halt
    2. Freeze
    3. Close the window