meta data for this page
  •  
Translations of this page:
  • en

This is an old revision of the document!

Fiber Comb Control


  • Start fiber comb control without and after fiber laser program!
  • To optimize CEO-frequency:
    1. “play” with the arrows in P-Control Laser
  • To optimize a small Rep-error-signal:
    1. Move in steps Forward/Backward in Repitition Rate Control
  • In Lockbox Rep Rate is locked disabled (red), because it is not connected to the menlosystem electronics.

possible errors:

  • If the programm doesn´t start: Maybe COM Port wrong (should be COM1 in device manager)!
    1. Start NI Device Monitor;
    2. if NI card (PCI 6221) is not available: Maybe a Re-Install of NIDAQ helps (in the software/comb folder): enables PCI-6221 card