We use toptica electronics:

1. Turning the main-key to on
2. Push the green button. The green LED will go on!
3. Switch on the toggle (=Kippschalter) from the laserdiode.
4. Switch on the toggle from the TA, if he is seeded!

If the switches are on, then not steps 3. & 4.

1. Both switches (Laserdiode/TA) is not required!
2. Push the red button. The green LED will go out!
3. Turning the main-key to “mains”

Typical efficiencies at 916 nm:

• Isolators: 80 %
• AOMs: 50-60 %
• Fiber coupling: 50 %

Typical values for the laser:

• Frequency: 327.5293 THz (doubled upstairs directly behind SHG: 655.058 566 THz)
• Power after ECDL: ~12 mW (@ ~90 mA)
• Power after TA: ~200 mW (@ ~1000 mA)
• TA current should be <1.2A otherwise the fiber stabilization will soar (=aufschwingen)

Typical values in front fibers:

• Power before fiber for wavemeter/comb/mode analysis cavity:~12 mW
• Power before AtomLabFiber: ~30 mW → 15 mW upstairs before TA
• Power to R2: ~2.5 mW

Typical values for the resonators:

• In front of telescope: 2.2 mW
• In front of AOM: 1.5 mW
• In front of fiber: 450 µW
• 100 µW between Isolator and BS
• 50 µW in front of Resonator

Typical values for locking signals:

• PDH error signal locked ~500 mV PP / unlocked ~200 mV PP
• Intensity Error signal ~2 mV PP / DC:
• Fiber Stabilization Locked ~200 mV PP / Unlocked ~2 Volt PP

Manuals and Datasheets