====== TracerDAQ ======
{{  :groups:mg:tracerdaq.jpg?100}}
===== DAQ Hardware settings =====
  * Optimum: +/- 2V. If there is more voltage, then are the resolution of the fluctuation bad.
  * You can change the time-range in the program //TracerDAQ//

===== Software settings =====

  * Select //Strip Chart//
  * Push //Run//
{{:groups:mg:tracerdaq_start_-_strip_chart.jpg?400|}}\\
  * You can change the range under: Edit -> Scan Rate/Trigger Settings 
  * Push //OK//
<note important>The memory will be very fast full for high scan ranges!</note>
{{:groups:mg:stripchart_scanrate.jpg?400|}}\\
  * You have to set the //DAQ Range/Mode// (=Input Voltage) to the right value!
  * In this window, you can see the error messages, like //not connected//!
{{:groups:mg:stripchart_hardware.jpg?400|}}\\
  * Push //Play/Start//
{{:groups:mg:tracerdaq_stripchart.jpg?400|}}\\


**Channels on RedLab-Card:**
\\ 0: R1 Inner T OOL
\\ 1: R2 Inner T OOL
\\ 2: R1 PDH Out
\\ 3: R1 Intens Out
\\ 4: R2 PDH Out
\\ 5: R2 Intens Out
\\ 6: R1 Vacuum
\\ 7: ECDL              

Current Setup: Check Dokumente Folder