====== Fiberlaser ======
===== Software Installation =====

  * Verion name: FiberLaserv6.9\\ {{  :groups:mg:fiber_laser.jpg?100|}}
  * Manual: {{ :groups:mg:private:resonatoren:reslabcomputers:fiberlaser-v6.9.pdf |}}

===== Usage =====
<note important>First start FiberLaser for better autotuning and afterwards Fiber Comb Control for controlling Repetition Rate Stepper Motor and CEO Tuner </note>
Close the program //"Fiber Comb Control"// and lock out the CEO- & REP-PID in the rack, otherwise you can´t optimize the comb!
  * Push //Yes// \\
{{:groups:mg:fiber_laser1.jpg?300|}}   
  * Push //OK// \\
{{:groups:mg:fiber_laser_2.jpg?300|}}

  * If you **turn off and on** the freuqency comb, then push in the order:
    - //Reset// 
    - //Auto on//
    - //Enable on//
<note important>The program is done, if all four boxes [//Laser on//, //Modelocked//, //Autoscramble//, //Enabled//] are green!</note>
   * For **closing** the software:
     - //Halt//
     - //Freeze//
     - Now you can optimize CEO-frequency, therefore play with the arrows //Stg 1//-//Stg 4// for the squeezer. Thereby you have to show the CEO-frequency on the Specki and afterwards show the Beat-Signal with 914nm-laser. If one beat is bad, you found a bad modelock point! And don´t forget to optimize the Beat-Signal with 914nm-laser with the PCF and SHG controllers!
     - Close the window\\

  * Possible **problems**:
    - If you can´t modelocked the laser. Don´t worry maybe the fs Laser and Amplifier is off. Then push:
      - Push //Laser on// 
      - Push //Amplifier on//
    - If the "Scramble Settings arrows" don´t move and the step width are 0. Than change the "step width" from 0 to 3 or 5. Afterwards push the " Send" button. 
{{:groups:mg:fiber_laser_3.jpg?800|}}