====== Fiber Comb Control ======
 {{  :groups:mg:fiber_control_comb.jpg?100|}}
===== Installation informations =====
  * Install first NI-drivers and LabView
  * Version Fiber Comb Control: v0.4.14\\
  * after installation put following config files in (if they were not installed automatically)...\FiberComb\etc:
       -  beatcontrol
       - fibercomb - Copy.setup
       - fibercomb.setup
       - fibercomb.setup.generic-0.4.14
       - fibercomb2 -Copy.setup
       - fibercomb2.setup
  * Change COM port under device manager to COM 1

===== Usage informations =====
<note important>First start FiberLaser for better autotuning and afterwards Fiber Comb Control for controlling Repetition Rate Stepper Motor and CEO Tuner </note>
  * Start //fiber comb control// without and after //fiber laser// program!
  * To optimize CEO-frequency:
    - "play" with the arrows in //P-Control Laser//
  * To optimize a small Rep-error-signal:
    - Move in steps //Forward/////Backward// in //Repitition Rate Control//
  * In //Lockbox Rep Rate// is //locked// disabled (red), because it is not connected to the menlosystem electronics. 

{{:groups:mg:fiber_comb_pic.jpg?800|}}



==== possible errors:====
  * If the programm doesn´t start: Maybe COM Port wrong (should be COM1 in device manager)!
    - Start NI Device Monitor; 
    - if NI card (PCI 6221) is not available: Maybe a Re-Install of NIDAQ helps (in the software/comb folder): enables PCI-6221 card