Differences

This shows you the differences between two versions of the page.

--- groups:mg:tracerdaq [2016/12/13 12:50] – steffen
+++ groups:mg:tracerdaq [2020/01/14 08:57] (current) – removed ssauer
@@ Line 1: / Line 1: @@
-====== TracerDAQ ======
-===== DAQ Hardware settings =====
-  * Optimum: +/- 2V. If there is more voltage, then are the resolution of the fluctuation bad.
-  * You can change the time-range in the program //TracerDAQ//
-===== Software settings =====
-  * Select //Strip Chart//
-  * Push //Run//
-{{:groups:mg:tracerdaq_start_-_strip_chart.jpg?400|}}\\
-  * You can change the range under: Edit -> Scan Rate/Trigger Settings
-  * Push //OK//
-<note important>The memory will be very fast full for high scan ranges!</note>
-{{:groups:mg:stripchart_scanrate.jpg?400|}}\\
-  * You have to set the //DAQ Range/Mode// (=Input Voltage) to the right value!
-  * In this window, you can see the error messages, like //not connected//!
-{{:groups:mg:stripchart_hardware.jpg?400|}}\\
-  * Push //Play/Start//
-{{:groups:mg:tracerdaq_stripchart.jpg?400|}}\\
-**Channels on RedLab-Card:**
-\\ 0: R1 Inner T OOL
-\\ 1: R2 Inner T OOL
-\\ 2: R1 PDH Out
-\\ 3: R1 Intens Out
-\\ 4: R2 PDH Out
-\\ 5: R2 Intens Out
-\\ 6: R1 Vacuum
-\\ 7: ECDL