meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| groups:mg:tips:coils [2020/07/01 12:00] – [Getting started] wfriesen | groups:mg:tips:coils [2020/07/07 09:01] (current) – [Getting started] wfriesen | ||
|---|---|---|---|
| Line 26: | Line 26: | ||
| - Now slowly increase the Voltage until the water starts to drip out of the Output-Tee. Increasing the voltage too fast will cause the pump not to work. | - Now slowly increase the Voltage until the water starts to drip out of the Output-Tee. Increasing the voltage too fast will cause the pump not to work. | ||
| - If the water starts to circulate you can increase the Voltage to max 12V. | - If the water starts to circulate you can increase the Voltage to max 12V. | ||
| - | - | + | - Flush the coils for a couple of hours |
| + | - When you are done with flushing the coils you have to flush the coils with destilled water, to remove all residuals of the vinegar-water-mix (flush it with ~5 litres NOT CIRCULATING) | ||