Differences

This shows you the differences between two versions of the page.

--- groups:mg:tips:coils [2020/07/01 11:39] – created wfriesen
+++ groups:mg:tips:coils [2020/07/07 09:01] (current) – [Getting started] wfriesen
@@ Line 16: / Line 16: @@
 ===== Getting started =====
-  - ...
+  - Turn off the pump and chiller.
+  - Make some space where the bigger pipe is split for the upper and lower coils (underneath the S-MOT Laser-System).
+  - Put a box there and remove the big pipes from the Tee. Do this above the box, since the water will start to drain out of the big pipes.
+  - Close the big pipes using the blind plugs.
+  - Connect the pump to the Input-Tee (labels are on the smaller pipes).
+  - Put the pump into a box with water (you can use tap water) and vinegar essence (I used a quarter of a bootle).
+  - Fix the Outut-Tee so that the water will drip into the box again.
+  - Connect the pump to the Power supply (check that the voltage is reduced to zero).
+  - Now slowly increase the Voltage until the water starts to drip out of the Output-Tee. Increasing the voltage too fast will cause the pump not to work.
+  - If the water starts to circulate you can increase the Voltage to max 12V.
+  - Flush the coils for a couple of hours
+  - When you are done with flushing the coils you have to flush the coils with destilled water, to remove all residuals of the vinegar-water-mix (flush it with ~5 litres NOT CIRCULATING)