meta data for this page
Differences
This shows you the differences between two versions of the page.
| groups:mg:protocols:2016-09:labbookentry-2016-09-15 [2016/09/15 13:16] – created steffen | groups:mg:protocols:2016-09:labbookentry-2016-09-15 [2016/09/15 13:18] (current) – steffen | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ResLab: \\ | ResLab: \\ | ||
| - | Clocklaser (R1) is running fine; Outer Shield Temperature decreased by 20 mK \\ | + | Clocklaser (R1) is running fine; Outer Shield Temperature decreased by 20 mK for higher control range at 13.09. due to an instability at this time\\ |
| Frequency Comb is locked, but Beat signal is quite low -> Maybe new pump diodes necessary \\ | Frequency Comb is locked, but Beat signal is quite low -> Maybe new pump diodes necessary \\ | ||
| Reference Resonator (R2) broad linewidth problem: most probable dirt / oil on mirror from turbo pump maybe; EOM? \\ | Reference Resonator (R2) broad linewidth problem: most probable dirt / oil on mirror from turbo pump maybe; EOM? \\ | ||
| Line 20: | Line 20: | ||
| Temperature control ready \ Dual Meerstetter for baseplate & Laser diode \\ | Temperature control ready \ Dual Meerstetter for baseplate & Laser diode \\ | ||
| AOM breadboard not ready within 2 months \\ | AOM breadboard not ready within 2 months \\ | ||
| - | Waldemar can begin writing his thesis, put AOM into outlook; linewidth and stability measurement would be nice \\ | + | Waldemar can begin writing his thesis, put AOM breadboard |
| HiWi contract until december; maybe stop it earlier \\ | HiWi contract until december; maybe stop it earlier \\ | ||
| breadboard setup almost done, orders for AOMs prepared \\ | breadboard setup almost done, orders for AOMs prepared \\ | ||