meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| groups:mg:private:resonatoren:ring-down_box:start [2018/11/14 09:51] – [Microwave switch] rholst | groups:mg:private:resonatoren:ring-down_box:start [2019/03/25 09:24] (current) – [Microwave switch] rholst | ||
|---|---|---|---|
| Line 84: | Line 84: | ||
| {{: | {{: | ||
| Make sure that the input and output are as far apart as possible and the connections to the switch form a straight line. Otherwise the input line acts as an antenna and a part of the rf signal passes to the output if the switch is closed. For the same reason, try to make the wires within the box as short as possible. | Make sure that the input and output are as far apart as possible and the connections to the switch form a straight line. Otherwise the input line acts as an antenna and a part of the rf signal passes to the output if the switch is closed. For the same reason, try to make the wires within the box as short as possible. | ||
| + | |||
| + | Also make sure to solder the shielding of the IC directly to the box. It makes the switch work A LOT better. | ||