meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
groups:mg:private:resonatoren:ring-down_box:start [2018/09/04 12:40] – created ssauergroups:mg:private:resonatoren:ring-down_box:start [2019/03/25 09:24] (current) – [Microwave switch] rholst
Line 75: Line 75:
  
 <note important>Connect all ground pins to ground, also the housing</note> <note important>Connect all ground pins to ground, also the housing</note>
- {{:groups:mg:imagexxl.jpg?300|}}{{:groups:mg:bf165356-8251-4436-b131-b6efceffb0bd.jpeg?300|}}{{:groups:mg:9ef752f7-5989-4c0b-a359-1b3e317a268a.jpeg?300|+ {{:groups:mg:imagexxl.jpg?300|}}{{:groups:mg:bf165356-8251-4436-b131-b6efceffb0bd.jpeg?300|}} 
 + 
 +<note warning>Do **NOT** build it like this</note> 
 +{{:groups:mg:9ef752f7-5989-4c0b-a359-1b3e317a268a.jpeg?300|
 }} }}
  
 +Rather build it like this:\\
 +{{:groups:mg:private:resonatoren:ring-down_box:km010673_mikrowellenschalter.jpg?400|}}\\
 +Make sure that the input and output are as far apart as possible and the connections to the switch form a straight line. Otherwise the input line acts as an antenna and a part of the rf signal passes to the output if the switch is closed. For the same reason, try to make the wires within the box as short as possible.
  
 +Also make sure to solder the shielding of the IC directly to the box. It makes the switch work A LOT better.