meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
groups:mg:private:resonatoren:reslabcomputers:fiberlaser [2020/01/15 11:58] – ssauergroups:mg:private:resonatoren:reslabcomputers:fiberlaser [2020/01/15 11:59] (current) – ssauer
Line 5: Line 5:
   * Manual: {{ :groups:mg:private:resonatoren:reslabcomputers:fiberlaser-v6.9.pdf |}}   * Manual: {{ :groups:mg:private:resonatoren:reslabcomputers:fiberlaser-v6.9.pdf |}}
  
 +===== Usage =====
 <note important>First start FiberLaser for better autotuning and afterwards Fiber Comb Control for controlling Repetition Rate Stepper Motor and CEO Tuner </note> <note important>First start FiberLaser for better autotuning and afterwards Fiber Comb Control for controlling Repetition Rate Stepper Motor and CEO Tuner </note>
 Close the program //"Fiber Comb Control"// and lock out the CEO- & REP-PID in the rack, otherwise you can´t optimize the comb! Close the program //"Fiber Comb Control"// and lock out the CEO- & REP-PID in the rack, otherwise you can´t optimize the comb!