meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
groups:mg:private:resonatoren:reslabcomputers:fiberlaser [2020/01/14 09:52] – ssauergroups:mg:private:resonatoren:reslabcomputers:fiberlaser [2020/01/15 11:59] (current) – ssauer
Line 1: Line 1:
 ====== Fiberlaser ====== ====== Fiberlaser ======
-{{  :groups:mg:fiber_control_comb.jpg?100|}}+===== Software Installation ===== 
 + 
 +  * Verion name: FiberLaserv6.9\\ {{  :groups:mg:fiber_laser.jpg?100|}} 
 +  * Manual: {{ :groups:mg:private:resonatoren:reslabcomputers:fiberlaser-v6.9.pdf |}} 
 + 
 +===== Usage =====
 <note important>First start FiberLaser for better autotuning and afterwards Fiber Comb Control for controlling Repetition Rate Stepper Motor and CEO Tuner </note> <note important>First start FiberLaser for better autotuning and afterwards Fiber Comb Control for controlling Repetition Rate Stepper Motor and CEO Tuner </note>
 Close the program //"Fiber Comb Control"// and lock out the CEO- & REP-PID in the rack, otherwise you can´t optimize the comb! Close the program //"Fiber Comb Control"// and lock out the CEO- & REP-PID in the rack, otherwise you can´t optimize the comb!