meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision		Previous revision
groups:mg:private:resonatoren:reslabcomputers:fiber_comb_control [2020/01/14 09:52] – created ssauergroups:mg:private:resonatoren:reslabcomputers:fiber_comb_control [2020/01/14 12:05] (current) – ssauer
Line 1: Line 1:
 ====== Fiber Comb Control ====== ====== Fiber Comb Control ======
-{{  :groups:mg:fiber_control_comb.jpg?100|}}+ {{  :groups:mg:fiber_control_comb.jpg?100|}} 
 +===== Installation informations ===== 
 +  * Install first NI-drivers and LabView 
 +  * Version Fiber Comb Control: v0.4.14\\ 
 +  * after installation put following config files in (if they were not installed automatically)...\FiberComb\etc: 
 +       -  beatcontrol 
 +       - fibercomb - Copy.setup 
 +       - fibercomb.setup 
 +       - fibercomb.setup.generic-0.4.14 
 +       - fibercomb2 -Copy.setup 
 +       - fibercomb2.setup 
 +  * Change COM port under device manager to COM 1 
 + 
 +===== Usage informations =====
 <note important>First start FiberLaser for better autotuning and afterwards Fiber Comb Control for controlling Repetition Rate Stepper Motor and CEO Tuner </note> <note important>First start FiberLaser for better autotuning and afterwards Fiber Comb Control for controlling Repetition Rate Stepper Motor and CEO Tuner </note>
   * Start //fiber comb control// without and after //fiber laser// program!   * Start //fiber comb control// without and after //fiber laser// program!