meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
groups:mg:fiberlaser [2016/12/13 11:12] – steffengroups:mg:fiberlaser [2020/01/14 09:49] (current) – removed ssauer
Line 1: Line 1:
-====== Fiberlaser ====== 
-Close the program //"Fiber Comb Control"// and lock out the CEO- & REP-PID in the rack, otherwise you can´t optimize the comb! 
-  * Push //Yes// \\ 
-{{:groups:mg:fiber_laser1.jpg?300|}}    
-  * Push //OK// \\ 
-{{:groups:mg:fiber_laser_2.jpg?300|}} 
- 
-  * If you **turn off and on** the freuqency comb, then push in the order: 
-    - //Reset//  
-    - //Auto on// 
-    - //Enable on// 
-<note important>The program is done, if all four boxes [//Laser on//, //Modelocked//, //Autoscramble//, //Enabled//] are green!</note> 
-   * For **closing** the software: 
-     - //Halt// 
-     - //Freeze// 
-     - Now you can optimize CEO-frequency, therefore play with the arrows //Stg 1//-//Stg 4//. Thereby you have to show the CEO-frequency on the Specki and afterwards show the Beat-Signal with 914nm-laser. If one beat is bad, you found a bad modelock point! And don´t forget to optimize the Beat-Signal with 914nm-laser with the PCF and SHG controllers! 
-     - Close the window\\ 
- 
-  * Possible **problems**: 
-   -  If you can´t modelocked the laser. Don´t worry maybe the fs Laser and Amplifier is off. Then push: 
-    * Push //Laser on//  
-    * Push //Amplifier on// 
-{{:groups:mg:fiber_laser_3.jpg?800|}}