meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
groups:mg:fiberlaser [2016/12/13 10:26] – steffengroups:mg:fiberlaser [2020/01/14 09:49] (current) – removed ssauer
Line 1: Line 1:
-====== Fiberlaser ====== 
-Close the program //"Fiber Comb Control"//, otherwise you can´t optimize the comb! 
-  * Push //Yes// \\ 
-{{:groups:mg:fiber_laser1.jpg?300|}}    
-  * Push //OK// \\ 
-{{:groups:mg:fiber_laser_2.jpg?300|}} 
- 
-  * If you **turn off and on** the freuqency comb, then push in the order: 
-    - //Reset//  
-    - //Auto on// 
-    - //Enable on// 
-<note important>The program is done, if all four boxes [//Laser on//, //Modelocked//, //Autoscramble//, //Enabled//] are green!</note> 
-   * For **closing** the software: 
-     - //Halt// 
-     - //Freeze// 
-     - Close the window\\ 
-{{:groups:mg:fiber_laser_3.jpg?800|}}