Differences

This shows you the differences between two versions of the page.

--- groups:mg:fiber_comb_control [2016/11/29 10:03] – ssauer
+++ groups:mg:fiber_comb_control [2020/01/14 09:51] (current) – removed ssauer
@@ Line 1: / Line 1: @@
-====== Fiber Comb Control ======
-{{ :groups:mg:fiber_comb_pic.jpg?800|}}\\
-  * Start //fiber comb control// without and after //fiber laser// program!
-  * To optimize CEO-frequency:
-    - "play" with the arrows in //P-Control Laser//
-  * To optimize a small Rep-error-signal:
-    - Move in steps //Forward/////Backward// in //Repitition Rate Control//
-  * In //Lockbox Offset// is //locked// disabled (red), because it is not connected to the menlosystem electronics.
-==== possible errors:====
-  * If the programm doesn´t start: Maybe COM Port wrong (should be COM1 in device manager)!
-    - Start NI Device Monitor;
-    - if NI card (PCI 6221) is not available: Maybe a Re-Install of NIDAQ helps (in the software/comb folder): enables PCI-6221 card