meta data for this page
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| groups:mg:experiment:cameras:wincam [2015/06/03 09:11] – klaus | groups:mg:experiment:cameras:wincam [2016/06/10 14:31] (current) – klaus | ||
|---|---|---|---|
| Line 7: | Line 7: | ||
| TaperCamD20-15–UCD23: | TaperCamD20-15–UCD23: | ||
| * WinCamD with 20 x 15 mm 2.27:1 FO taper on the sensor | * WinCamD with 20 x 15 mm 2.27:1 FO taper on the sensor | ||
| - | * 2/3" CCD sensor for CW Pulsed, 1360 x 1024 pixels, 6.45 um | + | * 2/3" CCD sensor for CW Pulsed, 1360 x 1024 pixels |
| + | * Pixelsize: **ATTENTION** The manual states, it is 6.45 µm. But taking the physical dimension (20x15 cm) and amount of pixels into account, it is rather **14.6772 µm**, which is approximately 2.27 * 6.45 | ||
| If you have a TaperCamD series camera, press **Alt S** to reach the WinCamD Capture Setup dialog, and enter the appropriate PMF value in the WinCamD capture screen. | If you have a TaperCamD series camera, press **Alt S** to reach the WinCamD Capture Setup dialog, and enter the appropriate PMF value in the WinCamD capture screen. | ||
| Line 18: | Line 18: | ||
| ===== Shortcuts ===== | ===== Shortcuts ===== | ||
| + | Capture setup dialog: Alt+S | ||
| Start measurement: | Start measurement: | ||
| Stop measurement: | Stop measurement: | ||
| + | |||
| + | ===== Troubleshooting ===== | ||
| + | Sometimes the camera is not getting recognized. Open the capture setup dialog (Alt+S) and unplug + plug the camera. Now, the program should recognize the camera. | ||
| ===== Power Limits ===== | ===== Power Limits ===== | ||